Product Introductions：

Model	DAY04OIL0010EU
Materials	304 stainless steel, aluminum
Power	3W
LED Chip	Epistar LED
Lumens	250Lm
CRI	>80Ra
Beam angle	90°
Voltage	DC12-24V
Color	3000K,4000K,6000K
Others	Red,Green,Blue
Size	Ø48XH58mm,Opening size：Ø36-40mm,depth>62mm
IP Rate	IP67
Warranty	3 Years

Detail display：

1.Epistar COB LED

2.90degree beam angle

3.304 Stainless steel cover

4.Steel shrapnel

5.Waterproof nut

6.Waterproof connector

7.High temperature wire

8.6063 aluminum lamp body

 

INSTALLATION

Wiring method 1

 

Pre-wire laying (low-voltage end divided into positive and negative wiring)

1.Cut off the waterproof terminal of the lamp

2.Connect the lights in parallel to the pre-arranged main wire

3.After the main wire is connected to the constant voltage power supply/transformer, then connected to 110V/220V

  

Wiring method 2

 

1.Pre-wire laying (low-voltage end divided into positive and negative wiring)

2.Cut off the waterproof terminal of the lamp（Male end）

3. The extension wire is connected in parallel to the pre laid main wire

4. The male end of the waterproof terminal of the lamp is connected with the female end of the extension wire

5.After the main wire is connected to the constant voltage power supply/transformer, then connected to 110V/220V

 

Wiring method 3

1.The diversion and extension wire is 0.3 square wire.

2.1W lamp, it is recommended to connect up to 20 lamps per group

3.3W lamp, each group is recommended to connect up to 8 lamps per group

 

Installation method 1: direct opening installation

Wooden board, gypsum board, marble or already done wall, etc., you can directly open the hole to install, as follows

 

Installation method 2: Installation with embedded parts
Installed with pre-buried parts, generally applied to concrete, lawn, etc. to facilitate fixed lights, as follows：

 

 

 

http://www.hydgetlighting.com/